MAINTENANCE WORK ON THE ENGINE
Filling up with gear oil
x
15.4
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
Adding gear oil
x
15.5
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
–
Place a suitable container under the engine.
–
Remove gear oil drain plug
–
Completely drain the gear oil.
–
Thoroughly clean gear oil drain plug with magnet.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet and the seal ring and tighten it.
Guideline
Oil drain plug with magnet
300659-10
–
Remove screw cap
Gear oil
–
Mount and tighten screw cap.
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
300660-10
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
–
Check the gear oil level. (
–
Stand the motorcycle upright on a horizontal surface.
–
Remove gear oil level check screw
300661-10
–
Remove screw cap
–
Add gear oil until it flows out of the bore of the gear oil level screw.
Engine oil (15W/50) (
–
Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check
–
Mount and tighten screw cap
300660-11
with magnet.
M12x1.5
and fill up with gear oil.
0.50 l (0.53 qt.)
Engine oil (15W/50) (
p. 67)
.
.
p. 82)
M6
.
68
20 Nm
(14.8 lbf ft)
p. 82)
6 Nm (4.4 lbf ft)