5.3
Connecting devices to the server
The connectors for external devices are on the front and rear of the server.
I
Some of the devices that can be connected may require special
software, e.g. drivers (see the documentation for the connected device).
On the front of the server are a video connector (1) and three USB
connectors (2), see
I
Please use the video connector on the rear (see figure
connect the main monitor. Via this connector the default screen solution
is read. The video connector on the front can be used for temporary
tasks.
When a monitor is connected to the front video connector, the display
output is switched from the rear to the front connector. That is, both video
connectors cannot be used in parallel.
Figure 11: Connectors on the front
RX900 S2
figure
11.
Operating Manual
Hardware installation
12 on page
70) to
69