SECTION 10—RECLINER
Replacing Headrest/Back Upholstery
NOTE:!For!this!procedure,!refer!to!FIGURE 10.3.
Headrest Upholstery
1. Remove!the!headrest!pillow.!Refer!to!
Replacing!Headrest!Pillow!on!page 57.
2. Remove!the!six!mounting!screws!that!
secure!the!headrest!upholstery!to!the!
headrest!extension!tubes.
3. Secure!new!headrest!upholstery!onto!
headrest!extension!tubes!with!the!
existing!six!mounting!screws.
4. Install!headrest!pillow.!Refer!to!
Replacing!Headrest!Pillow!on!page 57.
Back Upholstery
1. Remove!one!knob!from!one!side!of!the!
spreader!bar.
2. Loosen,!but!DO!NOT!remove!the!
remaining!knob.
NOTE:!To!remove!and!install!the!bottom!two!
mounting!screws!of!the!back!upholstery,!the!
wheelchair!MUST!be!partially!folded.
3. Remove!the!twelve!mounting!screws!
that!secure!the!back!upholstery!to!the!
back!canes.
4. Secure!the!new!back!upholstery!to!the!back!canes!with!the!existing!twelve!mounting!
screws.!Securely!tighten.
5. Install!the!knob!removed!in!STEP!1!to!secure!spreader!bar!to!side!frame.!Securely!
tighten!both!knobs.
Adjusting Headrest/Back Upholstery Tension
NOTE:!For!this!procedure,!refer!to!FIGURE 10.4!on!page!59.
1. Rotate!the!spreader!bar!in!one!of!the!following!directions:
• Counterclockwise!(away!from!back!upholstery)!to!loosen!back/headrest!
upholstery.
• Clockwise!(towards!back!upholstery)!to!tighten!back/headrest!upholstery.
9000 Series
Headrest
Extension
Tube
Knob
Back
Cane
FIGURE 10.3 Replacing Headrest/Back
Upholstery
58
Headrest
Upholstery
Mounting
Screws
Back
Upholstery
Mounting
Screws
Part No. 1056953