Replacing Desk/Full Length Armrest Pad And/Or Clothing Guards; (Fixed Height Arms Only); Removing Or Replacing Armrest (9000 Xt/9000Xt Recliner/9000Xdt Wheelchairs) - Invacare 9000 SL Owner's Operator And Maintenance Manual

ARMS
REPLACING DESK/FULL LENGTH
ARMREST PAD AND/OR CLOTHING
GUARDS (FIXED HEIGHT ARMS ONLY)
(FIGURE 3)
Armrest Pad
1. Remove the mounting screws that secure the
armrest pad to the armrest assembly.
2. Replace armrest pad and securely tighten with
the existing mounting screws.
Clothing Guard
1. Remove the four (4) mounting screws that se-
cure the existing clothing guard to the armrest
assembly.
2. Install NEW clothing guard and securely tighten
with the existing mounting screws.
Mounting
Screws
Clothing
Guard
Mounting
Screws
FIGURE 3 - REPLACING DESK/FULL LENGTH
ARMREST PAD AND/OR CLOTHING GUARDS

(FIXED HEIGHT ARMS ONLY)

Armrest Pad
Armrest
Assembly
Mounting
Screws
REMOVING OR REPLACING ARMREST
(9000 XT/9000XT RECLINER/9000XDT
WHEELCHAIRS) (FIGURE 4)
WARNING
Make sure the armrest release lever is in the
locked position before using the wheelchair.
Removing Armrests
1. Unlock the armrest by turning the armrest re-
lease levers towards the outside of the wheel-
chair.
2. Lift armrest completely out of arm sockets from
the wheelchair.
Replacing Armrests
NOTE: Armrest release levers MUST be in the
unlocked position when placing armrests into
the arm sockets.
1. Place armrest into arm sockets located on the
side of the wheelchair.
2. Lock the armrest by turning the armrest release
levers towards the inside of the wheelchair.
Armrest
Release
Lever
Arm
Socket
FIGURE 4 - REMOVING OR REPLACING
ARMREST (9000 XT/9000XT RECLINER/
9000XDT WHEELCHAIRS)
19
PROCEDURE 5
A
R
M
S
Armrest
Armrest
Release
Lever
Arm Socket