Error Messages - Brother HL-5440D Service Manual

Error Message
Replace Toner
Self-Diagnostic
Size Error DX
Size Mismatch
Storage Full
Toner Low
Description
The toner sensor detected no toner remaining
or the number of rotations of the developer
roller has reached the upper limit.
Rechecking the error after the power switch
was turned OFF and then ON again because
an error was detected by the center thermistor
of the fuser unit.
(This message is displayed for approximately
15 minutes when the machine is restarted after
error code 5800 has occurred.)
The registration front sensor detected that the
paper fed was smaller than or larger than the
specified size in duplex printing mode.
Printing on a paper size not supported for
duplex printing was attempted from the driver.
When printing from the MP tray, the size of
paper set in the MP tray does not match the
size specified by the driver.
When printing from paper tray 1, the size of
paper set in paper tray 1 does not match the
size specified by the driver.
When printing from paper tray 2, the size of
paper set in paper tray 2 does not match the
size specified by the driver.
Data cannot be saved because storage data
area in the memory is full.
The toner sensor detected that the toner
remaining has fallen below the specified level
or the developer roller counter has exceeded
the specified value.
2-18
Error Refer
codes to:
6300 2-36
5900 2-35
8900 2-42
9900 2-47
9000 2-45
9100 2-45
9200 2-45
0D00 2-28
6700 2-36
Confidential