Set One Push Demo Function (Function Code: 28) - Brother HL-5440D Service Manual

1.3.7 Set One Push Demo function (function code: 28)

<Function>
This function is to implement Demo printing by pressing the [Go] button, and is mainly used
for sales promotion at dealers. This function is disabled once printing is performed from the
computer. Change the setting to enable the function.
OnePushDemo = ON (enabled)
OnePushDemo = OFF (disabled)
The setting currently selected is marked "*".
<Operation Procedure>
(1) Press the [
"Maintenance 28" on the LCD.
(2) Press the [OK] button. "OnePushDemo=ON*" is displayed on the LCD.
When the current setting is OFF, "OnePushDemo=ON" (without "*") is displayed on the
LCD.
(3) Press the [
or "OnePushDemo=OFF" when disabling this function.
(4) Press the [OK] button. The setting currently displayed is saved, and the machine returns
to the initial state of maintenance mode.
(5) To cancel operation and return to the initial state of maintenance mode, press the
[Cancel] button.
Note:
• Once the One Push Demo function is enabled, this will not be disabled even when
printing is performed from the computer as long as the power switch is not turned
OFF. However, if the power switch is turned OFF and then ON again after the One
Push Demo function was enabled, this function will be disabled when printing is
performed from the computer.
] or [ ] button in the initial state of maintenance mode to display
] or [ ] button to display "OnePushDemo=ON" when enabling this function
5-13
Confidential