Brother HL-5440D Service Manual page 57

LED
When printing from the MP tray, paper tray 1, or
paper tray 2, the size of paper set in the MP tray,
paper tray 1 or paper tray 2 does not match the size
specified by the driver.
Printing on a paper size not supported for duplex
printing was attempted from the driver.
The T1 paper feed sensor detected that paper tray
1 was not set.
The eject sensor does not detect paper pass after
the registration rear sensor detected the end of
paper pass.
The registration front sensor detected that the paper
fed was smaller than or larger than the specified
size in duplex printing mode.
The registration front sensor does not detect paper
pass within the specified time after the T1 or T2
paper feed sensor detected paper pass.
The registration front sensor does not detect paper
pass within the specified time after the paper was
picked up from the MP tray.
When the power switch was turned ON, the eject
sensor detected paper pass or detected that the
fuser cover was open.
When printing with the tray designation set to
AUTO, the MP paper empty sensor, T1 paper feed
sensor and T2 paper feed sensor all detected that
there was no paper set in the MP tray, paper tray 1
and paper tray 2.
When printing from the MP tray, the MP paper
empty sensor detected that there was no paper set
in the MP tray.
When printing from paper tray 1 or 2, the T1 or T2
paper feed sensor detected that there was no paper
set in paper tray 1 or 2.
There is no paper set in the MP tray when feeding
from the MP tray is designated from the driver.
There is insufficient memory to expand PC-print
data.
Log registration failed.
Type of problem
2-21
Error Refer
codes to:
9000 2-45
9100 2-45
9200 2-45
9900 2-47
8500 2-41
8800 2-42
8900 2-42
8A00 2-43
8B00 2-43
8C00 2-44
8D00 2-44
9600 2-47
9300 2-45
9400 2-46
9500 2-46
9A00 2-48
C700 2-50
0C01
0C02
2-28
0C03
0C04
Confidential