Table of Contents
Advertisement
D
e
t
a
i
l
s
P
a
g
e
f
o
r
L
D
e
t
a
i
l
s
P
a
g
e
f
o
r
L
IP Address
Subnet Mask
RIP Protocol Control
DHCP Server
Configuration
A
N
1
A
N
1
Type in private IP address for connecting to a local private
network (Default: 192.168.1.1).
Type in an address code that determines the size of the network.
(Default: 255.255.255.0/ 24)
Disable deactivates the RIP protocol. It will lead to a
interruption of the exchange of routing information between
routers.
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network so
it automatically dispatch related IP settings to any local user
configured as a DHCP client. It is highly recommended that you
leave the router enabled as a DHCP server if you do not have a
DHCP server for your network.
Enable Server - Let the router assign IP address to every host in
the LAN.
Disable Server – Let you manually assign IP address to every
host in the LAN.
Relay Agent –Specify which subnet that DHCP server is located
the relay agent should redirect the DHCP request to.
Start IP Address - Enter a value of the IP address pool for the
DHCP server to start with when issuing IP addresses. If the 1st
IP address of your router is 192.168.1.10, the starting IP address
must be 192.168.1.11 or greater, but smaller than 192.168.1.254.
IP Pool Counts - Enter the maximum number of PCs that you
want the DHCP server to assign IP addresses to. The default is
49
Vigor3200 Series User's Guide
Advertisement
Table of Contents
