Table of Contents
Advertisement
L
A
N
2
,
L
A
N
3
,
L
A
N
L
A
N
2
,
L
A
N
3
,
L
A
With the multi-subnet feature offered by Vigor router, LAN2 ~ LAN4 are used for different
subnets.
Network
Configuration
For NAT Usage
For Routing Usage
DHCP Server
Configuration
4
N
4
Enable – enable the configuration for such LAN.
Disable – disable the configuration for such LAN.
Click this item to invoke NAT usage.
Click this item to invoke Routing usage.
IP Address - Type in private IP address for connecting to a local
private network (Default: 192.168.1.1).
Subnet Mask - Type in an address code that determines the size of
the network. (Default: 255.255.255.0/ 24)
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network so it
automatically dispatch related IP settings to any local user
configured as a DHCP client. It is highly recommended that you
leave the router enabled as a DHCP server if you do not have a
DHCP server for your network.
If you want to use another DHCP server in the network other than
the Vigor Router's, you can let Relay Agent help you to redirect
the DHCP request to the specified location.
Enable Server - Let the router assign IP address to every host in
the LAN.
Disable Server - Let you manually assign IP address to every host
in the LAN.
Start IP Address - Enter a value of the IP address pool for the
DHCP server to start with when issuing IP addresses. If the 1st IP
address of your router is 192.168.1.1, the starting IP address must
be 192.168.1.2 or greater, but smaller than 192.168.1.254.
IP Pool Counts - Enter the maximum number of PCs that you
want the DHCP server to assign IP addresses to. The default is 50
and the maximum is 253.
Gateway IP Address - Enter a value of the gateway IP address for
the DHCP server. The value is usually as same as the 1st IP address
of the router, which means the router is the default gateway.
109
Vigor3200 Series User's Guide
Advertisement
Table of Contents
