For using IPSec-based service, such as IPSec or L2TP with IPSec Policy, you have to set
general settings in IKE/IPSec General Setup, such as the pre-shared key that both
parties have known.
3.
Go to Remote Dial-In User. Click on one index number to edit a profile.
4.
Set Dial-In settings to as shown below to allow the remote user dial-in to build VPN
connection.
If an IPSec-based service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in IPSec General Setup above.
279
Vigor3200 Series User's Guide