Table of Contents
Advertisement
User Name
Password
VJ Compression
IKE Authentication
Method
IPSec Security Method
My WAN IP
Remote Gateway IP
Remote Network IP/
Remote Network Mask
Local Network IP / Local Display the local network IP and mask for TCP / IP
Vigor3200 Series User's Guide
If you uncheck the checkbox, the connection type you select
above will apply the authentication methods and security
methods in the general settings.
This field is applicable when you select PPTP or L2TP with or
without IPSec policy above.
This field is applicable when you select PPTP or L2TP with or
without IPSec policy above.
VJ Compression is used for TCP/IP protocol header
compression. This field is applicable when you select PPTP or
L2TP with or without IPSec policy above.
This group of fields is applicable for IPSec Tunnels and L2TP
with IPSec Policy when you specify the IP address of the remote
node. The only exception is Digital Signature (X.509) can be set
when you select IPSec tunnel either with or without specify the
IP address of the remote node.
Pre-Shared Key - Check the box of Pre-Shared Key to invoke
this function and type in the required characters (1-63) as the
pre-shared key.
Digital Signature (X.509) –Check the box of Digital Signature
to invoke this function and select one predefined Profiles set in
the VPN and Remote Access >>IPSec Peer Identity.
This group of fields is a must for IPSec Tunnels and L2TP with
IPSec Policy when you specify the remote node.
Medium- Authentication Header (AH) means data will be
authenticated, but not be encrypted. By default, this option is
active.
High- Encapsulating Security Payload (ESP) means payload
(data) will be encrypted and authenticated. You may select
encryption algorithm from Data Encryption Standard (DES),
Triple DES (3DES), and AES.
This field is only applicable when you select PPTP or L2TP
with or without IPSec policy above. The default value is 0.0.0.0,
which means the Vigor router will get a PPP IP address from the
remote router during the IPCP negotiation phase. If the PPP IP
address is fixed by remote side, specify the fixed IP address
here. Do not change the default value if you do not select PPTP
or L2TP.
This field is only applicable when you select PPTP or L2TP
with or without IPSec policy above. The default value is 0.0.0.0,
which means the Vigor router will get a remote Gateway PPP IP
address from the remote router during the IPCP negotiation
phase. If the PPP IP address is fixed by remote side, specify the
fixed IP address here. Do not change the default value if you do
not select PPTP or L2TP.
Add a static route to direct all traffic destined to this Remote
Network IP Address/Remote Network Mask through the VPN
connection. For IPSec, this is the destination clients IDs of
phase 2 quick mode.
214
Advertisement
Table of Contents
