Wds - Draytek Vigor3200 Series User Manual

SSID
Authentication Mode
Configure via Push
Button
Configure via Client
PinCode
4 . 1 2 . 6 W D S
4 . 1 2 . 6 W D S
WDS means Wireless Distribution System. It is a protocol for connecting two access points
(AP) wirelessly. Usually, it can be used for the following application:
Provide bridge traffic between two LANs through the air.
Extend the coverage range of a WLAN.
To meet the above requirement, two WDS modes are implemented in Vigor router. One is
Bridge, the other is Repeater. Below shows the function of WDS-bridge interface:
Display the SSID1 of the router. WPS is supported by SSID1
only.
Display current authentication mode of the router. Only
WPA2/PSK and WPA/PSK support WPS.
Click Start PBC to invoke Push-Button style WPS setup
procedure. The router will wait for WPS requests from wireless
clients about two minutes. The WPS LED on the router will
blink fast when WPS is in progress. It will return to normal
condition after two minutes. (You need to setup WPS within
two minutes)
Please input the PIN code specified in wireless client you wish
to connect, and click Start PIN button. The WPS LED on the
router will blink fast when WPS is in progress. It will return to
normal condition after two minutes. (You need to setup WPS
within two minutes)
231 Vigor3200 Series User's Guide