Connecting The 8550 Wsg Management Port To A Router Or Network Switch; Procedure 3-11 To Connect The 8550 Wsg Management Port To A Router Or Network Switch - Alcatel-Lucent OmniAccess 8550 Installation Manual

11 In the Default Gateway field, enter the default gateway address for
the 8550 WSG.
A confirmation window appears. Click OK
12 Connect the 8550 WSG to a router or network switch, as described
in Procedure
13 Log back in to the 8550 WSG Management Portal from another
workstation which is on the same network where you connected the
management port cable.
Upon logging in, you are asked to the accept the configuration
changes. Click OK.
Warning — You have 10 minutes (600 seconds) to log back in and
accept the changes, or the gateway reverts to the previous settings.
3.12 Connecting the 8550 WSG management port to a
router or network switch
Use this procedure to connect the 8550 WSG management port to a
router or network switch.
Procedure 3-11 To connect the 8550 WSG management
port to a router or network switch
1 After you have performed Procedure 3-10, remove the crossover
cable that connects the PC to the management port at the rear of the
8550 WSG.
2 Connect a straight cable from the management port to the desired
router or network switch.
3 Ping the 8550 WSG to test that it is connected to the network.
Alcatel-Lucent OmniAccess 8550 WSG Installation Guide, Release 2.0
September 2007 3HE03334AAAATQZZA Edition 02
3 — Installing and connecting the 8550 WSG
3-11 and Procedure 3-12.
3-25