Procedure 3-7 To Convert The Cable Management Arm For A Right-Hand Swing - Alcatel-Lucent OmniAccess 8550 Installation Manual

3 — Installing and connecting the 8550 WSG
Note —
have to remove the arm to access some components on the rear of the
8550 WSG.
Procedure 3-7 To convert the cable management arm for
a right-hand swing
1 Detach the arm from the retaining bracket by pulling the pin and lifting
the arm, as shown in Figure 3-12.
Figure 3-12 Detaching the arm from the bracket
2 Remove the spring from the arm brace, as shown in Figure 3-13.
3-16 Alcatel-Lucent OmniAccess 8550 WSG Installation Guide, Release 2.0
After you configure the arm for a right-hand swing, you may
1
2
September 2007 3HE03334AAAATQZZA Edition 02
19284