Mandatory regulations
Rack installation precautions
To reduce the risk of personal injury or damage to the equipment,
observe the following:
•
The leveling jacks are extended to the floor.
•
The full weight of the rack rests on the leveling jacks.
•
The stabilizing feet are attached to the rack if it is a single-rack
installation.
•
The racks are coupled together in multiple-rack installations.
•
Only one component is extended at a time. A rack may become
unstable if more than one component is extended for any reason.
•
You are careful when pressing the component rail release latches
and sliding the component into the rack. The slide rails could pinch
your fingertips.
•
You load the rack from the bottom up and load the heaviest item
into the rack first.
•
You do not attempt to move equipment racks without adequate
assistance, due to their height and weight.
•
You do not attempt to move an equipment rack on an incline that is
greater than 10 degrees from horizontal.
•
You do not attempt to move a fully loaded equipment rack.
Remove equipment from the rack before moving the rack not
attempt to recharge the battery.
Preventing electrostatic discharge and safety procedures
A discharge of static electricity from a finger or other conductor may
damage system boards or other static-sensitive devices. This type of
damage may reduce the life expectancy of the device.
xii
Alcatel-Lucent OmniAccess 8550 WSG Installation Guide, Release 2.0
September 2007
3HE03334AAAATQZZA Edition 02