Replacing A Hard Drive; Procedure B-4 To Replace A Hard Drive - Alcatel-Lucent OmniAccess 8550 Installation Manual

2 Install a new power supply.
i
ii
iii
iv
v
B.5

Replacing a hard drive

Use this procedure to replace a hard drive.

Procedure B-4 To replace a hard drive

1 Remove a hard drive from its bay.
i
ii
2 Install a hard drive into the empty hard drive bay.
i
ii
iii
Alcatel-Lucent OmniAccess 8550 WSG Installation Guide, Release 2.0
September 2007 3HE03334AAAATQZZA Edition 02
Slide the power supply unit into the empty power supply bay
until it clicks in place.
Connect the power cord to the 8550 WSG.
Close the cable management arm.
Ensure that the back panel power supply LED is green. See
chapter 5 for information on LEDs.
Ensure that the front panel external health LED is green. See
chapter 5 for information on LEDs.
Push down on the drive extraction handle tab on the front of the
hard drive.
Lift the handle, and pull it gently until the hard drive slides out.
Insert the hard drive into the bay slot guides, and slide it into the
slot until it seats into the socket on the disk backplane.
Close the drive extraction handle by pushing it downward until
it clicks into place.
Ensure that the online LED status is green. See chapter
information on LEDs.
B. Replacing system components
5 for
B-5