Procedure 4-1 To Power Up The 8550 Wsg; Initializing The 8550 Wsg Management Portal; Procedure 4-2 To Log In To The 8550 Wsg Management Portal To Initialize The System - Alcatel-Lucent OmniAccess 8550 Installation Manual

4 — Getting started
4.1 Powering up the 8550 WSG
Use this procedure to power up the 8550 WSG. The system takes
approximately 15 minutes to boot as it performs the system self-tests.

Procedure 4-1 To power up the 8550 WSG

1 Press the Power On button.
2 After the system boots up, check the status of the Power On button
LED on the front panel to ensure the system is running properly. See
chapter
4.2

Initializing the 8550 WSG Management Portal

After you have installed and connected the 8550 WSG, you must log
on to the 8550 WSG Management Portal to initialize the system.
Note 1 —
the first time, perform Procedure
address on the PC that connects to the 8550 WSG Management
Portal.
Note 2 —
admin and password admin. After you have initialized the 8550 WSG
Management Portal, Alcatel-Lucent strongly recommends that you
change the default password. See the OmniAccess 8550 WSG
Configuration and Administration Guide for more information. This
guide is available from the Help menu in the 8550 WSG Management
Portal.
Procedure 4-2 To log in to the 8550 WSG Management
Portal to initialize the system
1 Type http://192.168.1.1:8080/webportal/ in your browser address.
The 8550 WSG Management Portal login window appears, as
shown in Figure 4-1.
4-2 Alcatel-Lucent OmniAccess 8550 WSG Installation Guide, Release 2.0
5 for information on how to interpret LEDs.
Before you log in to the 8550 WSG Management Portal for
A default administrator account exists with the username
September 2007
3-10 to configure the 8550 WSG IP
3HE03334AAAATQZZA Edition 02