Power Cords; Power Supplies - Alcatel-Lucent OmniAccess 8550 Installation Manual

Power cords

To reduce the risk of electric shock or damage to the equipment,
observe the following:
•
You must use a power cord rated for the 8550 WSG and for the
voltage and current marked on the electrical ratings label of the
8550 WSG. The voltage and current rating of the cord must be
greater than the voltage and current rating marked on the
8550 WSG.
•
Do not place objects on AC power cords or cables. Arrange them
so that no one may accidentally step on or trip over them.
•
Do not pull on a cord or cable. When unplugging from the electrical
outlet, grasp the cord by the plug.
•
Make sure that the total ampere rating of all products plugged into
an extension cord or power strip does not exceed 80% of the
ampere ratings limit for the extension cord or power strip.
•
Do not disable the power cord grounding plug. The grounding plug
is an important safety feature.
•
Plug the power cord into a grounded (earthed) electrical outlet.

Power supplies

Installation of the 8550 WSG must comply with local and regional
electrical regulations governing the installation of information
technology equipment by licensed electricians. The 8550 WSG is
designed to operate in installations covered by NFPA 70, 1999 Edition
(National Electric Code) and NFPA-75, 1992 code for Protection of
Electronic Computer/Data Processing Equipment). See table
electrical power ratings.
Caution —
power fluctuations and temporary interruptions.
Alcatel-Lucent OmniAccess 8550 WSG Installation Guide, Release 2.0
September 2007 3HE03334AAAATQZZA Edition 02
Use a regulating UPS to protect the 8550 WSG from
Mandatory regulations
A-1 for
ix