Stand Assembly - Central Machinery 60564 Owner's Manual & Safety Instructions

Stand Assembly

(continued)
4. Set the Face Plate (1) onto the stand
assembly and fasten to the top SIDE
mounting holes on Front and Rear Legs.
NOTE: Be sure that the belt opening on the Face Plate
is positioned away from the switch. See Figure 4, right.
5. Slide the Inner Plate (9) under the opposite end
of the Face Plate and fasten together using the
TOP mounting holes. Then fasten to the top
middle holes on the Connecting Plate to the other
end of the Face Plate. See Figure 5, right.
6. Set the Fixed Plates (64) against each bottom
corner of the Front and Rear Legs, making sure the
mounting holes face downward. See Figure 6, right.
7. Use the Hex Bolts (53), Flat Washers (58) and
Nuts (60) to fasten the Feet (65-1), Pads (65)
and Fixed Plates together. See Figure 7, right.
8. Make sure Stand is level.
If level, tighten all hardware connections now.
Item 60564 For technical questions, please call 1-800-444-3353.
58 60
Figure 4
Figure 5
Inner
Plate (9)
Figure 6
Figure 7
Nut (60)
Fixed Plate (64)
Pad (65)
Feet (65-1)
Hex Bolt (53)
65-1
64
Face Plate (1)
Plate
Assembly
Face
Plate (1)
Fixed
Plate
(64)
Flat
Washer
(58)
Page 7