Phase 4: Motor To Stand Assembly; Pulley Mounting - Central Machinery 32208 Set Up And Operating Instructions Manual

FigUre FOr Step 3-2
SAW
BODY
1A
2. With at least one assistant, set the Band-
saw Body on the Stand. Make sure
that the holes in the Body line up with
the slots in the stand and that the pulley
lines up over the belt cutout as shown
above.
3. Insert the four Bolts (B) through one
Washer (H) each and into the holes in
the Saw Body from the top.
4. Attach each Bolt (B) using a Washer
(H), Lock Washer (J), and Nut (K).
Leave the hardware only finger tight.
5. Measure to verify that the saw body is
properly aligned to the stand. Make
needed adjustments, then wrench tight-
en the hardware.
SKU 32206/32208
(32208 shown)
For technical questions, please call 1-800-444-3353.

phASe 4: motor to Stand Assembly

D
required hardware
letter Description
D M8 x 25 Bolt
H M8 Washer
J M8 Lock Washer
K M8 Nut

pulley mounting

1. Remove the tape securing the key to
the shaft of the Motor (11A). Set the key
aside.
Note: The 32208, 4-Speed Bandsaw, uses
a different pulley arrangement than the
32206, Single-Speed Bandsaw. The
illustrations in this manual show the
4-Speed Bandsaw (32208).
FigUre FOr Step 4-2
N
2. (Step for 32208 only.) The key for this
saw's Motor shaft will need to be offset
by about 0.3" from the end of the shaft to
allow the Set Screw to function properly.
To assist in this, thread a M5 Nut (N) all
the way onto a M5 x 15 Pan Head Bolt
(G) for temporary use as a depth gauge.
h j
q'ty
(for this phase)
4
8
4
4
For SKU 32208 only
~0.3"
g
PAGE 12
K