Show Currently Used Configuration - Alcatel-Lucent OmniSwitch 6250 Management Manual

Managing CMM Directory Content

Show Currently Used Configuration

When a switch is booted, the certified and working directories are compared. If they are the same, the
switch runs from the working directory. If they are different, the switch runs from the certified directory.
A switch running from the certified directory cannot modify directory contents. (This topic is covered in
"Where is the Switch Running From?" on page
To check the directory from where the switch is currently running, enter the following command:
->show running-directory
CONFIGURATION STATUS
Running CMM
CMM Mode
Current CMM Slot
Running configuration
Certify/Restore Status
SYNCHRONIZATION STATUS
Flash Between CMMs
Running Configuration
Stacks Reload on Takeover: ALL STACKs (SW Activation)
The command returns the directory the switch is currently running from (working or certified) and which
CMM is currently controlling the switch (primary or secondary). It also displays whether the working and
certified directories are the same, and if a synchronization is needed between the primary and secondary
CMM.
The show running-directory
ence Guide.
OmniSwitch 6250/6450 Switch Management Guide
5-4.)
: PRIMARY,
: DUAL CMMs,
: 1,
: WORKING,
: CERTIFY NEEDED
: SYNCHRONIZED,
: NOT AVAILABLE,
command is described in detail in the OmniSwitch 6250/6450 CLI Refer-
May 2012
Managing the Directory Structure (Non-Redundant)
page 5-23