Show Currently Used Configuration - Alcatel-Lucent OmniSwitch 6850-48 Management Manual

Managing the Directory Structure (Non-Redundant)

Show Currently Used Configuration

When a switch is booted, the certified and working directories are compared. If they are the same, the
switch runs from the working directory. If they are different, the switch runs from the certified directory.
A switch running from the certified directory cannot modify directory contents. (This topic is covered in
"Where is the Switch Running From?" on page
To check the directory from where the switch is currently running, enter the following command:
-> show running-directory
CONFIGURATION STATUS
Running CMM
CMM Mode
Current CMM Slot
Running configuration
Certify/Restore Status
SYNCHRONIZATION STATUS
Flash Between CMMs
Running Configuration
Stacks Reload on Takeover: ALL STACKs (SW Activation)
To check the directory from where the switch is currently running, enter the following command9000:
-> show running-directory
CONFIGURATION STATUS
Running CMM
CMM Mode
Current CMM Slot
Running configuration
Certify/Restore Status
SYNCHRONIZATION STATUS
Running Configuration
NIs Reload on Takeover
The command returns the directory the switch is currently running from (working or certified) and which
CMM is currently controlling the switch (primary or secondary). It also displays whether the working and
certified directories are the same, and if a synchronization is needed between the primary and secondary
CMM.
The show running-directory
page 5-22
5-4.)
: PRIMARY,
: DUAL CMMs,
: 1,
: WORKING,
: CERTIFY NEEDED
: SYNCHRONIZED,
: NOT AVAILABLE,
: PRIMARY,
: MONO CMMs,
: A,
: WORKING,
: CERTIFY NEEDED
: NOT SYNCHRONIZED,
: 3
command is described in detail in the OmniSwitch CLI Reference Guide.
OmniSwitch AOS Release 6 Switch Management Guide
Managing CMM Directory Content
September 2009