NTP Specifications
NTP Specifications
RFCs supported
Platforms Supported
Maximum number of NTP servers per client 3
NTP Defaults Table
The following table shows the default settings of the configurable NTP parameters:
NTP Defaults
Parameter Description
Specifies an NTP server from which
this switch receives updates
Used to activate client
Used to activate NTP client
broadcast mode
Used to set the advertised broadcast
delay, in microseconds
page 4-2
1305–Network Time Protocol
OmniSwitch 6250, 6450
Command
ntp server
ntp client
ntp broadcast
ntp broadcast-delay
OmniSwitch 6250/6450 Switch Management Guide
Configuring Network Time Protocol (NTP)
Default Value/Comments
version: 4
minpoll: 6
prefer: no
key: 0
disabled
disabled
4000 microseconds
May 2012