Asr901-Multicast Source - Cisco ASR 901 Command Reference Manual

Chapter 1 CLI Command Reference

asr901-multicast source

To send the multicast packets to the CPU enabling it to transmit register packets to Rendezvous Point
(RP), use the asr901-multicast source command on the interface configuration mode. Use the no form
of the command to disable transmission of multicast packets.
Syntax Description
This command has no arguments or keywords.
Command Default
This command is enabled by default.
Command Modes Interface configuration (config-if)#
Command History Release
15.4(1)S
Usage Guidelines
This command should be enabled on the SVI interface that is connected to the traffic source. After the
configuration, normal Protocol Independent Multicast sparse mode (PIM-SM) register process begins.
Examples
This example shows how to enable multicast on a Cisco ASR 901 series router:
Router# configure terminal
Router(config)# interface type number
Router(config-if)# asr901-multicast source
OL-26031-07
asr901-multicast source
no asr901-multicast source
Modification
This command was introduced on the Cisco ASR 901 Series Aggregation
Services Routers.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
asr901-multicast source
1-13