Cisco ASR 901 Command Reference Manual page 81

Chapter 1 CLI Command Reference
name
To specify the name of a iSCSI target in the target profile on the GGSN, use the name command in iSCSI
interface configuration mode. To remove the IP address configuration, use the no form of the command.
Syntax Description
target_name
Command Default No default behavior or values.
Command Modes iSCSI interface configuration
Command History Release
15.1(2)SNG
Usage Guidelines Use the name command to specify the name of the SCSI target in an iSCSI target interface profile on
the GGSN.
Examples This example shows how to create Ethernet VLAN 20, name it test20, and add it to the VLAN database:
Router# configure terminal
Router(config)# vlan 20
Router(config-vlan)# name test20
Router(config-vlan)# end
Related Commands Command
gprs iscsi
ip
ip iscsi target-profile
port
OL-26031-07
name target_name
no name target_name
Name of the SCSI target.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Description
Configures the GGSN to use the specified iSCSI profile for
record storage.
Specifies the IP address of the target on the SAN.
Creates an iSCSI interface profile for an SCSI target (or
modifies an existing one), and enters iSCSI interface
configuration mode.
Specifies the number of the TCP port on which to listen for
iSCSI traffic.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
name
1-67