Synce State Slave - Cisco ASR 901 Command Reference Manual

Chapter 1 CLI Command Reference

synce state slave

To configure the synchronous ethernet copper port as slave, use the synche state slave command. Use
the no form of the command to disable the configuration.
Syntax Description
This command has no arguments.
Command Default None.
Command Modes Interface configuration mode.
Command History Release
15.1(2)SNG
Usage Guidelines The synce state slave command configures the synchronous ethernet copper port as the slave in the
interface configuration mode.
Examples The following command configures the ethernet copper port as slave:
Router(config-if)# synce state slave
Related Commands Command
synce state master
OL-26031-07
synce state slave
no synce state slave
Modification
This command was introduced on the Cisco ASR 901 router.
Description
Configures the synchronous ethernet copper port as master.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
synce state slave
1-197