Cisco ASR 901 Command Reference Manual page 35

Chapter 1 CLI Command Reference
channel-protocol (interface)
To enable Link Aggregation Control Protocol (LACP) on an interface to manage channeling, use the
channel-protocol command in interface configuration mode. Use the no form of this command to
deselect the protocol.
Syntax Description
lacp
Command Modes
Interface configuration
Command History Release
15.1(2)SNG
Usage Guidelines
This command is valid on multiple interfaces (for example, Fast Ethernet) and routers and switches.
Examples The following example shows how to set the lacp.
(config-if)# channel-protocol lacp
OL-26031-07
channel-protocol {lacp}
no channel-protocol
Specifies LACP to manage channeling.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
channel-protocol (interface)
1-21