Network-Clock Hold-Off - Cisco ASR 901 Command Reference Manual

Chapter 1 CLI Command Reference

network-clock hold-off

To configure general hold-off timer in milliseconds, use the network-clock hold-off command in the
interface configuration mode. Use the no form of the command to remove the configuration.
Syntax Description
<50-10000>
Command Default
The default value is 300 milliseconds.
Command Modes
Interface configuration
Command History Release
15.1(2)SNG
Usage Guidelines
Displays a warning message for values below 300 ms and above 1800 ms.
Examples This example configures the hold-off timer:
Router(config-if)#network-clock hold-off 1000
Related Commands Command
network-clock
synchronization ssm
option
OL-26031-07
network-clock hold-off {0 | <50-10000>}
no network-clock hold-off {0 | <50-10000>}
Sets the hold-off timer. The default value is 300 milliseconds.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Description
Configures the router to work in a synchronized network mode as described
in G.781.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
network-clock hold-off
1-73