Payload-Size - Cisco ASR 901 Command Reference Manual

payload-size

payload-size
Specifies the size of the payload for packets on a structured CEM channel.
Syntax Description
payload-size
Defaults
The default payload size for a structured CEM channel depends on the number of timeslots that
constitute the channel. The default payload size for a T1 is 192 bytes; the default size for an E1 is 256
bytes.
Command Modes
CEM circuit configuration
Command History Release
15.1(2)SNG
Examples
The following example shows how to specify a sample rate:
Router# config t
Router(config)# interface cem 0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# payload-size 256
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-88
payload-size [payload-size]
Specifies the size of the payload for packets on a structured CEM channel.
Valid values are 32–512. The default payload size for a T1 is 192 bytes; the
default size for an E1 is 256 bytes.
Note
The default payload size is calculated as follows:
8 x number of timeslots x 1 ms packetization delay
Modification
Support for this command was introduced on the Cisco ASR 901 router.
The payload size must be a multiple of the number of timeslots for
the CEM channel.
Chapter 1 CLI Command Reference
OL-26031-07