Transport Ipv4 - Cisco ASR 901 Command Reference Manual

transport ipv4

transport ipv4
Specifies the IP version, traffic type (multicast or unicast), and interface that a PTP clock port uses to
send traffic.
Syntax Description
unicast
multicast
interface
slot/port
subslot number
port
negotiation
Defaults
The IP version, transmission mode, and interface are not specified for exchanging timing packets.
Command Modes
PTP clock-port configuration mode
Command History Release
15.1(2)SNG
Examples
The following example shows how to enable ptp priority1 value:
Router# configure terminal
Router(config)# ptp clock ordinary domain 0
Router (config-ptp-clk)# clock-port MASTER Master
Router (config-ptp-port)# transport ipv4 unicast interface loopback 23 negotiation
Router(config-ptp-port)# exit
Router(config-ptp-clk)# exit
Related Commands Command
clock-port
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-202
transport ipv4 {unicast | multicast} interface slot/port [negotiation]
no transport ipv4 {unicast | multicast} interface slot/port [negotiation]
Specifies that the router sends unicast PTP traffic.
Specifies that the router sends multicast PTP traffic.
Specifies the interface used to send PTP traffic.
Backplane slot number and port number on the interface. Refer to your
hardware installation manual for the specific values and slot numbers.
Defines the subslot on the router in which the HWIC is installed.
Port number of the controller. Valid numbers are 0 and 1. The slash mark (/)
is required between the slot argument and the port argument.
(Optional) Enables dynamic discovery of slave devices and their preferred
format for sync interval and announce interval messages.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
Description
Specifies the mode of a PTP clock port.
Chapter 1 CLI Command Reference
OL-26031-07