Efd Notify G8032 - Cisco ASR 901 Command Reference Manual

Chapter 1 CLI Command Reference

efd notify g8032

To notify G.8032 of failures, use the efd notify g8032 command in the Ethernet CFM service
configuration mode. To remove this configuration, use the no form of this command.
Syntax Description
efd notify g8032
Command Default Monitoring and notifying G.8032 for failures is disabled.
Command Modes Ethernet CFM service configuration (config-ecfm-srv) #
Command History Release
15.4(3)S
Usage Guidelines When G8032 ring links are monitored by CFM sessions, use the efd notify g8032 command under CFM
service configuration to notify G8032 of failures, if any.
Examples The following example shows how to use the efd notify g8032 command:
Router # configure terminal
Router(config)# ethernet cfm global
Router(config)# ethernet cfm domain MD4 level 4
Router(config-ecfm)# service 1 evc evc1 vlan 99 direction down
Router(config-ecfm-srv)# continuity-check
Router(config-ecfm-srv)# continuity-check interval 3.3ms
Router(config-ecfm-srv)# offload sampling 6000
Router(config-ecfm-srv)# efd notify g8032
Related Commands Command
ethnernet cfm global
ethernet cfm domain
level
continuity-check
offload sampling
OL-26031-07
efd notify g8032
no efd notify g8032
Monitors and notifies G.8032 of failures.
Modification
This command was introduced on the Cisco ASR 901 Routers.
Description
Enables Ethernet CFM globally on a router.
Defines a CFM maintenance domain at a particular maintenance level.
Enables sending and receiving of continuity check messages.
Configures the sampling rate for the offloaded CFM session.
Cisco ASR 901 Aggregation Services Router Command Reference Guide
efd notify g8032
1-39