Synce State Master - Cisco ASR 901 Command Reference Manual

synce state master

synce state master
To configure the synchronous ethernet copper port as master, use the synche state master command.
Use the no form of the command to disable the configuration.
Syntax Description
This command has no arguments.
Command Default None
Command Modes Interface configuration
Command History Release
15.1(2)SNG
Usage Guidelines The synce state master command configures the synchronous ethernet copper port as the master in the
interface configuration mode.
Examples The following command configures the ethernet copper port as master:
Router(config-if)# synce state master
Related Commands Command
synce state slave
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-196
synce state master
no synce state master
Modification
This command was introduced on the Cisco ASR 901 router.
Description
Configures the synchronous ethernet copper port as slave.
Chapter 1 CLI Command Reference
OL-26031-07