Panel Test - Furuno FSV-35 Operator's Manual

8. MAINTENANCE, TROUBLESHOOTING
8.11.3

Panel test

The panel test checks the keys, controls and trackball of the control unit. Select [Panel
Test] from the [Test] menu to do this test.
0 0
0 0
0 0
0 0
*When two control units are connected, 1 is for main control unit and 2 is for sub control unit.
Key check: Press each key one by one. A key is normal if its corresponding on-screen
location shows 1 while the key is pressed and 0 when the key is released. The power
keys (ON and OFF) can not be checked.
Control check: Operate each control one by one. A control is normal if;
Clockwise rotation: Positive value
Counterclockwise rotation: Negative value
No rotation: "0"
Lever check: Press the lever upward or downward. Normal conditions are 1 for up-
ward and 2 for downward.
Trackball check: Operate the trackball. X-Y coordinates of trackball position are dis-
played. Normal conditions are as follows.
Rightward: X positive, Leftward: X negative
Upward: Y positive, Downward: Y negative
8-10
PANEL TEST
0 0
0 0 0
0 0
0 0 0
0
0 0
0 0
0 0 0 0 0
0 0
0 0 0
0 0
0 0 0
0
0 0
0 0
0 0 0 0 0
Press MENU/ESC key to cancel.
0
0 0
0 0
X = 0
0 0
Y = 0
0
0 0 0 d = 0
0
0 0
0 0
X = 0
0 0
Y = 0
0
d = 0
0 0 0
0 0
0 0