3. VERTICAL MODE
3.10
How to Adjust Beam Width
The width of the horizontal beam can be adjusted from the [Beam Width] menu.
1. Press the MENU/ESC key to show the main menu.
2. Select [TX/RX Setting] then push the left-click button.
3. Press the H/V/S key to select the [V] tab.
4. Select [Beam Width] then push the left-click button.
5. Select [Beam] then push the left-click button.
6. Select [S] (raise setting) or [T] (lower setting) to adjust the beamwidth. The set-
ting range is 0 to 5.
7. Select [Quit] on the setting box then push the left-click button to close the box.
8. Long-press the MENU/ESC key to close all menus.
3-15