Self-Check; Procedure; Panel Test - Furuno DS-30 Operator's Manual

Self-Check

Procedure

Panel Test

10. SELF-CHECK
The DS-30 has a self-check facility for general diagnosis of the major
circuits. If an unusual symptom is encountered during operation of the
equipment, perform the self-check. If the self-check shows an
equipment fault, report the result when calling for service.
1. Call up the main menu by pressing the MENU key.
2. Select the self-test item and press the MENU key. The sub-menu
as shown below is displayed.
3. Select a self-test item to be executed and press the MENU key.
As each self-test item is protected (locked), the following alert
appears.
This item is locked.
Do you want to change setting?
4. Select "Yes" and press the MENU key twice, and the selected
self-test is executed.
The panel test checks the operation panel keys for proper operation
10-1
SELF-TEST
PANEL TEST : EXECUTE?
SYSTEM TEST : EXECUTE?
CONT. TEST : EXECUTE?
TX/RX TEST : OFF
SET SIM SPD : 0.0kn
SPD SIM ON : OFF
kn/m/s
END