21: Time Control Delay; 22: 2Voice Pitch Shifter - Roland RS-5 Owner's Manual

Chapter 6. Effect Settings

21: TIME CONTROL DELAY

You can use the modulation lever and knobs to change the
delay time and pitch in real time (p. 71). Lengthening the
delay will lower the pitch, and shortening it will raise the
pitch.
fig.MFX-21
L in
Balance D
Time Control Delay
Feedback
R in
Balance D
Delay (Delay Time) #1
Adjust the time delay from the direct sound until when each
delay sound is heard.
Value: 200–1000 [ms]
Acceleration
This parameter adjusts the time over which the Delay Time
will change from the current setting to a newly specified
setting. The rate of change for the Delay Time directly affects
the rate of pitch change.
Value: 0–15
Feedback (Feedback Level) #2
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Value: -98– +98 [%]
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Value: 200–8000 [Hz], BYPASS
Pan (Output Pan)
Adjust the stereo location of the delay sound. L64 is far left, 0
is center, and 63R is far right.
Value: L64–63R
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
96
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127

22: 2VOICE PITCH SHIFTER

A Pitch Shifter shifts the pitch of the direct sound. This 2-
voice pitch shifter has two pitch shifters, and can add two
pitch shifted sounds to the direct sound.
fig.MFX-22
L in
Level Balance A
2Voice Pitch Shifter
Level Balance B
R in
CoarseA (Coarse Pitch A) #1
Adjust the pitch of Pitch Shift A in semitone steps (-2–+1
octaves).
Value: -24– +12 [semi]
Fine A (Fine Pitch A) #1
Make fine adjustments to the pitch of Pitch Shift A in 2-cent
steps (-100–+100 cents).
One cent is 1/100th of a semitone.
Value: -100– +100 [cent]
Pan A (Output Pan A)
Adjust the stereo location of the Pitch Shift A sound. L64 is
far left, 0 is center, and 63R is far right.
Value: L64–63R
Pre Delay A (Pre Delay Time A)
Adjust the time delay from when the direct sound begins
until the Pitch Shift A sound is heard.
Value: 0.0–500 [ms]
Balance D
L out
PanA L
Balance W
PanA R
PanB L
PanB R Balance W
R out
Balance D