Setting The Amount Of Chorus And Reverb - Roland RS-5 Owner's Manual

Using the Convenient Functions in Performances

Setting the Amount of Chorus and Reverb

fig.Q-51
1
Set the chorus or reverb to ON (refer to previous section).
2
Press [EDIT], getting the indicator to light.
3
Use VALUE [-]/[+] to select "Performance Part."
4
Press [ENTER].
5
Press PART [
amount of effect is to be set.
6
If setting the chorus, press [7]; if setting the reverb, press [8].
fig.Q-52
7
Use VALUE [-]/[+] to select the value (1–127).
8
Press [EDIT].
The [EDIT] indicator goes out, and you are returned to the previous screen.
46
]/[ ] to select the Part for which the
3,7 5 6 2,8 4
Separate settings for the
amount of chorus and
reverb applied can be made
for each individual Part in
a Performance (p. 56).
• When Key Mode (p. 34)
is set to Split or Dual, you
can select only the Upper
Part and the Lower Part.
• Note that even if the
chorus or reverb is set to
ON, no effect is applied if
each Send Level is set to 0.
If you wish to make
settings for other Parts,
repeat steps 5–7.