Setting The System Exclusive Receive Switch; Restoring Saved Settings To The Rs-5/9 - Roland RS-5 Owner's Manual

Chapter 8. Saving Your Settings
Setting the System Exclusive
Receive Switch
When returning saved settings to the RS-5/9, set the
Exclusive Receive switch to ON. With the factory settings,
this will be "ON."
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select "System Setup."
3. Press [ENTER].
4. Press the numeric key [4] several times to select "System
Exclusive."
fig.R08-08
* If you hold down [SHIFT] and press [4], you will return to the
previous item.
5. Use VALUE [-]/[+] to set "ON."
6. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.
116
Restoring saved settings to the
RS-5/9
* Be aware that when you restore data to the RS-5/9, the data in
the RS-5/9 will be overwritten and lost.
Notes
fig.(!)
When data is being written to the User Memory, the
message "KEEP POWER ON!" appears in the display; be
sure not to turn off the power while this message is
displayed.
If the power is turned off or interrupted while data is
being written to memory, the internal data may become
corrupted, and you may not be able to turn the power
back on. If you have confirmed that internal data has
been lost, or if a similar problem exists, consult your
Roland dealer or Roland Service. Note, however, that
Roland assumes no liability, including compensation, for
consequences arising from loss of data.
1. Use a MIDI cable to connect the MIDI OUT connector of
the external sequencer to the MIDI IN connector of the
RS-5/9.
2. Set the device ID number to the same setting as when
you performed the bulk dump.
System Setup Numeric Key [4]: Device ID (p. 115)
3. Turn on the exclusive receive switch.
System Setup Numeric Key [4]: System Exclusive (refer
4. Transmit (play back) the data from the external
sequencer.
When the transmitting is finished, you are returned to
the previous screen.
* Play back the external sequencer at the same tempo you used
when performing the bulk dump. If you use a faster tempo, the
data may not be restored correctly.
to the previous section)