Table of Contents
Advertisement
Modulation FX Parameters
37: TIME CTRL DELAY
A stereo delay in which the delay time can be varied smoothly.
L in
Time Ctrl Delay
Feedback
Feedback
Time Ctrl Delay
R in
Parameter
Value
Switch
OFF, ON
Depth Knob
DELAY TIME,
FEEDBACK,
BALANCE
Rate Knob
Delay Time
OFF, ON
(sync sw) #
Delay Time
1–1300 [msec]
(msec) #/
Delay Time
note (p. 31)
(note) #
Acceleration
0–15
Feedback #
-98–+98 [%]
200–8000 [Hz],
HF Damp
BYPASS
Low Gain
-15–+15 [dB]
High Gain
-15–+15 [dB]
D100:0W–
Balance #
D0:100W
Level
0–127
22
Balance D
2-Band EQ
Balance W
Balance W
2-Band EQ
Balance D
Explanation
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Specifies the parameter that is
controlled by the MODULATION FX
[RATE] knob.
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner's manual p. 24).
Adjusts the time until the delay is
heard.
Adjusts the speed which the Delay
Time changes from the current setting
to a specified new setting.
The rate of change for the Delay
Time directly affects the rate of pitch
change.
Adjusts the amount of the delay
sound that's fed back into the effect.
Negative "-" settings invert the phase.
Adjusts the frequency above which
sound fed back to the effect is filtered
out (BYPASS: no cut).
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the delay sound (W)
Output Level
38: TAPE ECHO
A virtual tape echo that produces a realistic tape delay sound. This
simulates the tape echo section of a Roland RE-201 Space Echo.
L out
L in
R in
R out
Parameter
Switch
Depth Knob
Rate Knob
Mode
Repeat Rate #
Intensity #
Bass
Treble
Head S Pan
Head M Pan
Head L Pan
Tape Distortion
W/F Rate
W/F Depth
Echo Level #
Direct Level #
Level
L out
Direct Level
Echo Level
Tape Echo
Echo Level
R out
Direct Level
Value
Explanation
OFF, ON
Turns the effect on/off.
Specifies the parameter that is
controlled by the MODULATION FX
REPEAT RATE,
[DEPTH] knob.
INTENSITY,
ECHO LEVEL,
Specifies the parameter that is
DIRECT LEVEL
controlled by the MODULATION FX
[RATE] knob.
Combination of playback heads to use
Select from three different heads with
different delay times.
S, M, L, S+M, S+L,
M+L, S+M+L
S: short
M: middle
L: long
Tape speed
0–127
Increasing this value will shorten the
spacing of the delayed sounds.
0–127
Amount of delay repeats
Boost/cut for the lower range of the
-15–+15 [dB]
echo sound
Boost/cut for the upper range of the
-15–+15 [dB]
echo sound
Independent panning for the short,
L64–63R
middle, and long playback heads
Amount of tape-dependent distortion
to be added
This simulates the slight tonal changes
0–5
that can be detected by signal-analysis
equipment. Increasing this value will
increase the distortion.
Speed of wow/flutter (complex
0–127
variation in pitch caused by tape wear
and rotational irregularity)
0–127
Depth of wow/flutter
0–127
Volume of the echo sound
0–127
Volume of the original sound
0–127
Output level
Advertisement
Table of Contents
