How To Save - Roland RS-5 Owner's Manual

Chapter 8. Saving Your Settings

How to Save

* When saving a Tone or Drum Set when Key Mode is set to
Split or Dual, the Tone or Drum Set assigned to the selected
Part is saved.
Notes
fig.(!)
When data is being written to the User Memory, the
message "KEEP POWER ON!" appears in the display; be
sure not to turn off the power while this message is
displayed.
If the power is turned off or interrupted while data is
being written to memory, the internal data may become
corrupted and you may not be able to turn the power
back on. If you have confirmed that the internal data has
been lost, or if a similar problem exists, consult the
retailer from whom you purchased the instrument, or
the nearest Roland Service Center. Note, however, that
Roland assumes no liability, including compensation, for
consequences arising from any loss of data.
* We recommend that you use the Bulk Dump operation (p.
115) to save important data to an external sequencer.
1. Press [UTILITY], getting the indicator to light.
2. Press VALUE [-]/[+] to select "Write Tone/Drum" or
"Write Performance."
* When saving Tones or Drum Sets, select "Write Tone/Drum."
When saving Performances, select "Write Performance."
3. Press [ENTER].
fig.R08-04exp
When saving Tones
When saving Drum Sets
When saving Performances
114
4. Press the numeric keys ([1]-[0]) to specify the save
destination number.
Tone: 001–128
Drum set: 001, 002
Performance: 001–128
* If you make a mistake, press [EXIT] and specify the number
once again.
* You can also specify the number by pressing VALUE [-]/[+].
In this case, there is no need to press [ENTER] in step 5.
5. Press [ENTER] to finalize the number.
6. Press [ENTER] once again to execute the Save operation.
After the Save operation is finished, the display will
indicate "Completed."
The [UTILITY] indicator goes out, and you are returned
to the previous screen.
* If you change a Tone's/Drum Set's settings without
having saved the Tone/Drum Set, and then attempt
to save the Performance, the following message
appears in the display. If this message does appear,
save the Tone/Drum Set with the changed settings
before saving the Performance.
fig.R08-05