17: Stereo Delay - Roland RS-5 Owner's Manual

Chapter 6. Effect Settings

17: STEREO DELAY

This is a stereo delay.
When Feedback Mode is NORMAL:
fig.MFX-17a
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
Balance D
When Feedback Mode is CROSS:
fig.MFX-17b
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
Balance D
Delay Left (Delay Time Left)
Adjust the time from the direct sound until when the left
delay sound is heard.
Value: 0.0–500 [ms]
Delay Right (Delay Time Right)
Adjust the time from the direct sound until when the right
delay sound is heard.
Value: 0.0–500 [ms]
Feedback (Feedback Level) #1
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Value: -98– +98 [%]
Feedback Mode
Select the way in which delay sound is fed back into the
effect.
Value
NORMAL: The left delay sound will be fed back into the left
delay, and the right delay sound into the right
delay.
CROSS: The left delay sound will be fed back into the
right delay, and the right delay sound into the
left delay.
92
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Phase Left (Feedback Phase Left)
Select the phase of the left delay sound.
Value
NORMAL: Phase is not changed.
INVERT: Phase is inverted.
Phase Right (Feedback Phase Right)
Select the phase of the right delay sound.
Value
NORMAL: Phase is not changed.
INVERT: Phase is inverted.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Value: 200–8000 [Hz], BYPASS
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance) #2
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127