Roland RS-5 Owner's Manual page 45

4
Press VALUE [-]/[+] to turn the effect on or off.
5
Press [EFFECTS ON/OFF].
Then the Reverb On/Off settings screen appears in the display.
fig.Q-50
6
Press VALUE [-]/[+] to turn the effect on or off.
7
Press [EFFECTS ON/OFF] to return to the original screen.
The [EFFECTS ON/OFF] indicator lights up whenever any of the three
effects is on.
When Using Multi-effects in Split or Dual Mode
The RS-5/9 cannot use more than one multi-effect at a time. Therefore, there
is a "Source" parameter which is used for selecting the multi-effect settings.
Settings Values
UPPER:
LOWER:
PERFORMANCE: The Performance's multi-effect settings are used. The
Thus, you should note that depending on the Source setting, some Parts
may not have multi-effects applied while in Split or Dual mode.
For more detailed information, refer to "Making Multi-Effects Settings" (p. 80).
Using the Convenient Functions in Performances
The Upper Tone's multi-effect settings are used. The
multi-effect is applied only to the Upper Part.
The Lower Tone's multi-effect settings are used. The
multi-effect is applied only to the Lower Part.
same multi-effect is applied to all Parts (1–16).
• You can return to the
original screen during
the operation by pressing
[EXIT].
• If all three effects are
turned off, the
[EFFECTS ON/OFF]
indicator light goes out.
45