08: Rotary - Roland RS-5 Owner's Manual

Chapter 6. Effect Settings

08: ROTARY

The Rotary effect simulates the sound of the rotary speakers
often used with the electric organs of the past.
Since the movement of the high range and low range rotors
can be set independently, the unique type of modulation
characteristic of these speakers can be simulated quite
closely. This effect is most suitable for electric organ Patches.
fig.MFX-08
L in
Rotary
R in
Low Slow (Low Frequency Slow Rate)
Adjust the slow speed (SLOW) of the low frequency rotor.
Value: 0.05–10.00 [Hz]
Low Fast (Low Frequency Fast Rate)
Adjust the fast speed (FAST) of the low frequency rotor.
Value: 0.05–10.00 [Hz]
Low Accel (Low Frequency Acceleration)
Adjust the time it takes the low frequency rotor to reach the
newly selected speed when switching from fast to slow (or
slow to fast) speed. Lower values will require longer times.
Value: 0–15
Low Level (Low Frequency Level)
Adjust the volume of the low frequency rotor.
Value: 0–127
High Slow (High Frequency Slow Rate)
Adjust the slow speed (SLOW) of the high frequency rotor.
Value: 0.05–10.00 [Hz]
High Fast (High Frequency Fast Rate)
Adjust the fast speed (FAST) of the high frequency rotor.
Value: 0.05–10.00 [Hz]
High Accel (High Frequency Acceleration)
Adjust the time it takes the high frequency rotor to reach the
newly selected speed when switching from fast to slow (or
slow to fast) speed. Lower values will require longer times.
Value: 0–15
High Level (High Frequency Level)
Adjust the volume of the high frequency rotor.
Value: 0–127
86
L out
R out
Separation
Adjust the spatial dispersion of the sound.
Value: 0–127
Speed #1
Simultaneously switch the rotational speed of the low
frequency rotor and high frequency rotor.
Value
SLOW: Slow down the rotation to the specified speed (the
Low Slow/Hi Slow values).
FAST: Speed up the rotation to the specified speed (the
Low Fast/Hi Fast values).
* When you want to use the pedal switch to switch the Rotary
rotation speed, select MFX PARAMETER 1 in Control Pedal
Assign (p. 73).
Level (Output Level) #2
Adjust the output level.
Value: 0–127