25: Gated Reverb; 26: Overdrive→Chorus - Roland RS-5 Owner's Manual

25: GATED REVERB

Gate Reverb is a special type of reverb in which the
reverberant sound is cut off before its natural length.
fig.MFX-25
L in
Balance D
Gated Reverb
R in
Balance D
Type (Gated Reverb Type)
Select the type of reverb.
Value
NORMAL: conventional gate reverb
REVERSE: backwards reverb
SWEEP1: the reverberant sound moves from right to left
SWEEP2: the reverberant sound moves from left to right
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the reverb sound is heard.
Value: 0.0–100 [ms]
Gate Time
Adjust the time from when the reverb is heard until when it
disappears.
Value: 5–500 [ms]
Low Gain
Adjust the gain of the low frequency range.
Value: -15– +15 [dB]
High Gain
Adjust the gain of the high frequency range.
Value: -15– +15 [dB]
Balance (Effect Balance) #1
Adjust the volume balance between the direct sound and the
reverb sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
reverb sound will be output.
Value: D100:0W–D0:100W
Level (Output Level) #2
Adjust the output level.
Value: 0–127
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Chapter 6. Effect Settings
26: OVERDRIVE→CHORUS
This effect connects an overdrive and a chorus in series.
fig.MFX-26
L in
Balance D
Overdrive Chorus
R in
Balance D
OD Drive
Adjust the degree of overdrive distortion. The volume will
change together with the degree of distortion.
Value: 0–127
OD Pan (Overdrive Pan) #1
Adjust the stereo location of the overdrive sound. L64 is far
left, 0 is center, and 63R is far right.
Value: L64–63R
Chorus Delay (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Value: 0.0–100 [ms]
Chorus Rate
Adjust the modulation speed of the chorus effect.
Value: 0.05–10.00 [Hz]
Chorus Depth
Adjust the modulation depth of the chorus effect.
Value: 0–127
Chorus Bal (Chorus Balance) #2
Adjust the volume balance between the overdrive sound that
is sent through the chorus and the overdrive sound that is
not sent through the chorus. With a setting of "D100:0W,"
only the overdrive sound will be output. With a setting of
"D0:100W," only the overdrive sound that is sent through
the chorus will be output.
Value: D100:0W–D0:100W
Level (Output Level)
Adjust the output level.
Value: 0–127
L out
Balance W
Balance W
R out
99