Setting Multi-Effects As On/Off For Individual Parts; Making Chorus Settings; Select The Type And Set Each Parameter - Roland RS-5 Owner's Manual

Setting Multi-Effects as On/Off
for Individual Parts
You can specify whether to have multi-effects used (ON), or
not used (OFF) for individual Parts only when Source is set
to PERFORMANCE.
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select "Performance Part."
3. Press [ENTER].
4. Press PART [
]/[
5. Press the numeric key [6] several times to select
"Switch."
fig.R06-04
6. Press VALUE [-]/[+] to select the value (OFF, ON).
7. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.

Making Chorus Settings

You can make different chorus settings for each individual
Performance.
There are eight types of chorus. You can select any one of
these. After selecting the Type, you can change the values for
each of the parameters.
Furthermore, you can set the chorus depth (the amount
applied) differently for each individual Part in a
Performance.
Select the Type and Set Each
Parameter
When you change the Chorus Type, eight different Chorus/
chorus parameters are changed automatically to the
optimum values. Rather than setting the chorus parameters
one by one, you can make the settings more easily by first
setting the Chorus Type and then changing only the
necessary parameters.
These settings can be made differently for each individual
Performance.
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select "Tone/Drum/
PFMCommon."
] to select the Part.
Chapter 6. Effect Settings
3. Press [ENTER].
4. Press the numeric key [7] several times to select the item
you wish to set.
fig.R06-05
* If you hold down [SHIFT] and press [7], you will return to the
previous item.
5. Use VALUE [-]/[+] to set the value.
* If you wish to make settings for other Parts, repeat steps 4–5.
6. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.
Type (Chorus Type)
You can choose from 8 types of chorus.
Value:
CHORUS1–4: General chorus settings. Adds
breadth and fullness to the sound.
FEEDBACK CHORUS: Chorus that produces a flanger-like
effect, creating a soft sound.
FLANGER: This effect produces a rising and
falling sweep reminiscent of a jet
airplane.
SHORT DELAY: This is a delay with a short delay
time.
SHORT DELAY(FB): This is a delay with a short delay time
and many repeats.
Pre-LPF (Chorus pre-low pass filter)
A low-pass filter can be applied to the sound coming into the
chorus to cut the high frequency range. Higher values will
cut more of the high frequencies, resulting in a more mellow
chorus sound.
Value: 0–7
Level (Chorus Level)
Sets the amount of the chorus sound.
Value: 0–127
Feedback (Chorus Feedback Level)
Sets the level at which the chorus sound is re-input (fed back)
into the chorus. By using feedback, a denser chorus sound
can be created. Higher values result in a greater feedback
level.
Value: 0–127
107