Resetting The Remote Controller - Integra DTR-7.7 Instruction Manual

Controlling Other Components—Continued
Remote Control Codes for Integra/Onkyo
Components Connected via
Integra/Onkyo components that are connected via
are controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Integra/Onkyo component
is connected with an
analog audio cable (RCA).
See page 36 for details.
2 Enter the appropriate remote control code
for the Remote Mode button.
• [DVD] Remote Mode button
5002: Integra/Onkyo DVD player with
• [CD] Remote Mode button
6002: Integra/Onkyo CD player with
• [MD] Remote Mode button
6008: Onkyo MD recorder with
• [CDR] Remote Mode button
6006: Onkyo CD recorder with
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that's not con-
nected via , use the following remote control codes:
• [DVD] Remote Mode button
5001: Integra/Onkyo DVD player without
(default)
• [CD] Remote Mode button
6001: Integra/Onkyo CD player without
(default)
• [MD] Remote Mode button
6007: Onkyo MD recorder without
• [CDR] Remote Mode button
6005: Onkyo CD recorder without
Note:
If you connect an -capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote opera-
tion to work properly, you must set the input display to
MD or CDR (see page 44).
Resetting the Remote Mode Buttons
You can reset a Remote Mode button to its default
remote control code.
1
cable and an
2
You can reset the remote controller to its default settings.
1
2
While holding down the Remote
Mode button that you want to
reset, press the TV [
The Remote indicator flashes three
times.
Press the Remote Mode button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] Remote Mode
buttons are preprogrammed with
remote control codes for controlling
Integra/Onkyo DVD players and CD
players respectively. When these but-
tons are reset, the preprogrammed code
is restored.

Resetting the Remote Controller

While holding down the
[Receiver] Remote Mode button,
press the [Standby] button.
The Remote indicator flashes five
times.
Press the [Receiver] Remote
Mode button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
] button.
85