Resetting Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Integra DTR-50.2 Instruction Manual

If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, use the follow-
ing remote control codes:
32900:
Integra/Onkyo Blu-ray Disc player
32901:
Integra/Onkyo HD-DVD player
70868:
Onkyo MD recorder without
71323:
Onkyo CD recorder without
82990:
Onkyo Dock without
Note
• If you connect a cassette tape deck to the TV/CD IN jack, or
connect an RI Dock to the to the TV/CD IN or VCR/DVR IN or
GAME IN jacks, for
Display accordingly

Resetting Remote Mode Buttons

You can reset a Remote Mode to its default remote con-
trol code.
1
While holding down Remote Mode that you want
to reset, press and hold down Home until Remote
Mode button lights (about 3 seconds).
2
Within 30 seconds, press Remote Mode again.
Remote Mode button flashes twice, indicating that
the button has been reset.
Each of Remote Mode is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.
Note
• The learning command is also reset.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down Receiver, press and hold
down Home until Receiver lights (about 3 sec-
onds).
2
Within 30 seconds, press Receiver again.
Receiver flashes twice, indicating that the remote
controller has been reset.
En
92
to work properly, you must set the Input
(➔ 27).

Controlling Other Components

By pressing Remote Mode that's been programmed with
the remote control code for your component, you can con-
trol your component as below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
91).
(➔
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the
some models). The TV must be able to receive remote
control commands via
AV receiver via HDMI. If controlling your TV via
doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the
(limited to some models). The component must be able to
receive remote control commands via
connected to the AV receiver via HDMI.
*1 The supported by the
system control function of the HDMI standard.
*1 (limited to
and be connected to the
*1
and be
is the CEC
AV receiver