Using The Multichannel Dvd Input - Integra DTR-7.7 Instruction Manual

Using the Multichannel DVD Input

Multi CH
Receiver
Enter
Using the Multichannel DVD Input
The multichannel DVD input is for connecting a compo-
nent with a 5.1/7.1-channel analog audio output, such as
a DVD player, DVD-Audio/SACD-capable player, or an
MPEG decoder. See page 26 for hookup information.
Press the [Receiver] Remote
Mode button, followed by the
[Multi CH] button.
The MULTI CH indicator appears on
the display.
Audio from the multichannel DVD
input will now be used for the DVD
input source.
Setup
MULTI CH indicator
Multichannel DVD Input Settings
1 While the DVD input is selected,
press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select "4. Input Setup,"
and then press [Enter].
Use the Up and Down [ ]/[ ]
buttons to select "2. MULTICH,"
and then press [Enter].
The MULTICH menu appears.
4-2.MULTICH
-----------DVD----------
3.XM Antenna Aiming
a.Input Channel:5.1ch
b.Subwoofer Sensitivity
3
Use the Up and Down [ ]/[ ]
buttons to select the settings,
and use the Left and Right
[ ]/[ ] buttons to change them.
The settings are explained below.
4
Press the [Setup] button.
Setup closes.
Input Channel
If you've connected a 7.1-channel audio output to the
multichannel DVD input, select 7.1ch. If you've con-
nected a 5.1-channel audio output, select 5.1ch.
Subwoofer Sensitivity
Some DVD players output the LFE channel from their
subwoofer output at 15 dB higher than normal. You can
change the subwoofer sensitivity to match your DVD
player. Note that this setting only affects signals con-
nected to the SUBWOOFER input jack of the multichan-
nel DVD input.
You can select 0 dB, +5 dB, +10 dB, or +15 dB.
If you find that your subwoofer is too loud, try the
+10 dB or +15 dB setting.
: 0dB
53