Connecting Components; Connecting The Power Cord - Integra DTR-7.7 Instruction Manual

Connecting Your Components—Continued
Connecting
Step 1: Make sure that each Integra/Onkyo component is connected to the AV receiver with an analog audio cable
(RCA).
Step 2: Make the
Step 3: If you're using an MD, CDR, or HDD component, change the Input Display (see page 44).
With (Remote Interactive), you can use the following special functions:
Auto Power On/Standby
When you start playback on a component connected via
on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components
connected via will also go on Standby. This function will not work with components connected to an AC OUTLET
on the AV receiver.
Direct Change
When playback is started on a component connected via
the input source. If your DVD player is connected to the AV receiver's multichannel DVD input, you'll need to press
the [Multi CH] button to hear all channels (page 53), as the Direct Change
Remote Control
You can use the AV receiver's remote controller to control your other
the remote controller at the AV receiver's remote control sensor instead of the component. You must enter the appropri-
ate remote control code first (see page 85).
Notes:
• Use only
cables are supplied with Integra/Onkyo players
(DVD, CD, etc.).
• Some components have two
connect either one to the AV receiver. The other
jack is for connecting additional
components.
• Connect only Integra/Onkyo components to
jacks. Connecting other manufacturer's compo-
nents may cause a malfunction.
• Some components may not support all
tions. Refer to the manuals supplied with your
other Integra/Onkyo components.

Connecting the Power Cord

Notes:
• Before connecting the power cord, connect all of your
speakers and AV components.
• Turning on the AV receiver may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different branch circuit.
• Do not use a power cord other than the one supplied
with the AV receiver. The supplied power cord is
designed exclusively for use with the AV receiver and
should not be used with any other equipment.
36
Components
connection.
cables for connections.
jacks. You can
-capable
, if the AV receiver is on Standby, it will automatically turn
, the AV receiver automatically selects that component as
-capable Integra/Onkyo components, pointing
REMOTE
CONTROL
e.g., CD player
func-
e.g., DVD player
• Never disconnect the power cord from the AV receiver
while the other end is still plugged into a wall outlet.
Doing so may cause an electric shock. Always discon-
nect the power cord from the wall outlet first, and then
the AV receiver.
1
2
function only selects the FRONT jacks.
R
ANALOG
AUDIO OUT
R
ANALOG
AUDIO OUT
Connect the supplied power cord
to the AV receiver's AC INLET.
Plug the power cord into an AC
wall outlet.
The Standby indicator lights up.
IN
L
R
CD
FRONT
L
R
DVD
L
L