Changing The Input Display; Minimum Speaker Impedance - Integra DTR-7.7 Instruction Manual

First Time Setup—Continued

Changing the Input Display

If you connect an
recorder, CD recorder, or next generation HDD-compat-
ible component, such as the Remote Interactive Dock, to
the TAPE IN/OUT or VIDEO 3 IN jacks, for
work properly, you must change this setting.
This setting can only be changed on the AV receiver.
1, 2
1
Press the [Tape] or [Video 3]
input selector button so that
"TAPE" or "VIDEO3" appears on
the display.
or
2
Press and hold down the [Tape]
or [Video 3] input selector button
(about 3 seconds) to change the
setting.
Repeat this step to select MD, CDR, or
HDD.
or
For the TAPE input selector, the setting
changes in this order:
For the VIDEO 3 input selector, the set-
ting changes in this order:
Note:
HDD can be selected for the TAPE input selector or
VIDEO 3 input selector, but not both at the same time.
44
-capable Onkyo MiniDisc
1, 2
→ → →
TAPE MD CDR
→ →
VIDEO 3 HDD VIDEO 3

Minimum Speaker Impedance

If you change this setting, you must run the automatic
speaker setup again (see page 38).
to
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Minimum Speaker Impedance to 4
ohms.
Note:
Before you change this setting, turn down the volume.
1
2
3
4
→
HDD
→
5
Notes:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
Use the Up and Down [
buttons to select "3. Speaker
Setup," and then press [Enter].
The Speaker Setup menu appears.
3.Speaker Setup
------------------------
0.Speaker Impedance 1.Speaker Impedance
2.Speaker Configuration
3.Speaker Distance
4.Level Calibration
5.THX Audio Setup
6.Equalizer Settings
Use the Up and Down [
buttons to select "Speaker
Impedance," and then press
[Enter].
Use the Left and Right [
buttons to select:
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Press the [Setup] button.
Setup closes.
]/[ ]
]/[ ]
]/[ ]